Table of Contents
Advertisement
Procedure
When the Web Cooling System is installed, thread the forms using the following
illustrations as a guide. The web will loosen in the Vacuum Unit (2) after leaving
Printer 1. The forms will also need to be threaded through the Air Bearing web
turn unit after leaving the Cooling Tower (1). The result is that the web is cooled
and then the forms are inverted 180° between Printer 1 and Printer 2.
The web is placed on top of the rollers of the vacuum unit with a loop of loose
Side 1
Side 2
3
Figure 65. Threading the Vacuum Unit and the Cooling Tower
web between them.
The Cooling Tower can be threaded using the following illustration as a guide.
1
2
Chapter 5. Working with forms
167
Advertisement
Table of Contents
