Table of Contents
Advertisement
10. To continue, make the printer Ready by selecting Start on the printer operator
194
Operating the InfoPrint 4100
v On the printer operator panel, press NPRO.
v On the Main touchscreen panel, select Advance Paper (NPRO).
If END OF FORMS appears, repeat this step again.
4. On the stacker control panel, press the stacker table Down switch and wait for
the stacker table to stop moving.
5. Open the stacker gate.
6. If you did not do an NPRO, leave 4 to 5 pages of blank forms attached to the
end of the job to ensure correct folding when you resume printing.
Do not attempt to remove a full stack from the stacker.
v Limit the maximum weight of the stack by breaking the output into small
stacks (start with a stack 150 mm (6 in.) high) by separating the forms at
convenient perforations.
v The stacker height is adjustable.
v Use a ruler, knife, or letter opener to break hard-to-reach perforations when
you separate forms.
v Follow these guidelines when you lift forms out of the stacker:
a. Ensure that you can stand safely without slipping.
b. Try to keep your back straight and balance the weight of the forms
between your feet.
c. Use a slow lifting force. Never move suddenly or twist when you
attempt to lift.
d. Lift by standing or by pushing up with your leg muscles. This action
removes the strain from the muscles in your back.
7. Remove the output from the stacker.
8. On the stacker control panel, press the table UP switch.
9. Close the stacker gate.
panel or on the Main touchscreen panel for the affected printer.
Note: You can adjust the stacker table to limit the stack height. This allows
you to adjust the height and weight of the printed forms. This adjustment can
cause the STACKER FULL message to appear more frequently. Remember that
Advertisement
Table of Contents
