Table of Contents
Advertisement
2. Adjust all tractor units. To adjust a unit, press the blue button (5) while
grasping the unit and slide it to the outermost position.
Note: Make sure the tractor slot (2) is in the tractorless feed mode (3). Position
(4) is tractor feed mode.
3. Ensure that the forms are aligned correctly.
4. Close the lower tractor covers.
5. Adjust the rear paper-edge guide as follows:
Note: This step applies to InfoPrint Models TS2 and TD3/4 when the Dual
Toner Mark/Side Verify Sensor feature (FC 4570) is installed.
a. Loosen the thumbscrew (2).
b. Slide the rear paper-edge guide (1) to the correct location for the current
paper width. The paper should be positioned against the vertical surface of
the guide (3) so that the sensor on the bottom side of the sensor mounting
plate can read side verify marks and registration marks, which are printed
on the outside edge of the paper. The edge guide is also used to guide the
paper in tractorless mode.
Chapter 5. Working with forms
109
Advertisement
Table of Contents
