Description - Dell Z9500 Command Reference Manual

Version
7.5.1.0
6.2.1.1
Usage When you enable debug spanning-tree bpdu for multiple interfaces, the
Information
software only sends information on BPDUs for the last interface specified.
Related protocol spanning-tree
Commands

description

Enter a description of the spanning tree.
Z9500
Syntax
description {description}
To remove the description from the spanning tree, use the no description
{description} command.
Parameters
description
Defaults none
Command SPANNING TREE (The prompt is "config-stp".)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
Related protocol spanning-tree
Commands
Spanning Tree Protocol (STP)
Description
Introduced on the C-Series.
Introduced on the E-Series.
— enters SPANNING TREE mode on the switch.
Enter a description to identify the spanning tree (80
characters maximum).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
— enters SPANNING TREE mode on the switch.
1771