Returning The Server To Operation; Server Filler Panel Requirements - Oracle X5-2L Service Manual

Returning the Server to Operation

After replacing components inside of the server, perform the procedures in the following
sections.
Description
Note server filler panel requirements.
Install the server top cover.
Install the fan door assembly top cover.
Install the disk cage cover.
Remove any antistatic measures.
Reinstall the server chassis in the rack.
Return the server to the normal rack position.
Reconnect power and data cables.
Power on the server.
Related Information
"Preparing for Service"
■

Server Filler Panel Requirements

The server might be shipped with module-replacement filler panels for storage drives and PCIe
cards. These filler panels are installed at the factory and must remain in the server until you
replace them with a purchased option.
Before you can install an optional server component into the server, you must remove the filler
panel from the location into which you intend to install the component. When you remove
a storage drive or a PCIe card from the server, you must install either a replacement for the
component removed or a filler panel.
Links
"Server Filler Panel Requirements" on page 225
"Install the Server Top Cover" on page 226
"Install the Fan Assembly Door" on page 228
"Install the Disk Cage Cover" on page 229
"Remove Antistatic Measures" on page 230
"Reinstall the Server in the Rack" on page 230
"Return the Server to the Normal Rack
Position" on page 231
"Reconnect Power and Data Cables" on page 233
"Power On the Server" on page 233
Returning the Server to Operation 225