Oracle X5-2L Service Manual page 80

Remove an NVMe Storage Drive From the Server
#
hotplug poweroff pcie13
#
hotplug list –lc
The following output appears for the NVMe drive that has been unmounted:
# hotplug list –lc
Connection State
Path
------------------------------------------------------------------
pcie13
4. Verify that the OK to Remove indicator (LED) on the NVMe storage drive is lit.
Remove an NVMe Storage Drive From the Server
Perform this procedure to physically remove an NVMe storage drive from the server.
1. Identify the physical location of the NVMe drive that you want to remove.
For storage drive locations, see
Verify that the OK to Remove indicator (LED) on the NVMe storage drive is lit.
2.
3. On the drive you plan to remove, push the latch release button to open the drive
latch.
See Figure
Grasp the latch and pull the drive out of the drive slot.
4.
5. Consider your next steps:
If you are replacing the drive, continue to
■
Storage Drive" on page
Server" on page
If you are not replacing the drive, install a filler panel in the empty drive slot to maintain
■
proper airflow and perform administrative tasks to configure the server to operate without
the drive.
For information on how to install a storage drive filler panel, see
Panels" on page
Verify Removal of an NVMe Storage Drive
To verify that the NVMe drive has been removed, type:
#
hotplug list –lc
The following output appears for the NVMe drive that you removed:
80 Oracle Server X5-2L Service Manual • May 2015
Description
PRESENT PCIe-Native /pci@7a,0/pci8086,2f08@3/pci111d,80b5@4
"Remove an HDD or SSD Storage Drive" on page
15.
80, and then
81.
226.
"Verify Removal of an NVMe
"Install an NVMe Storage Drive in the
73.
"Remove and Install Filler