Related Information; Required Tools; Preparing The Server For Component Replacement - Oracle X5-2L Service Manual

Required Tools

Note -
be completed when two of the three quorum members contain matching key identity properties.

Related Information

"Servicing Power Supplies (CRU)" on page 93
■
"Servicing the Front and Rear Storage Drive Backplanes (FRU)" on page 146
■
"Servicing the Motherboard Assembly (FRU)" on page 209
■
Required Tools
The server can be serviced with the following tools:
Antistatic wrist strap
■
Antistatic mat
■
Hex/flat head screwdriver
■
No. 2 Phillips screwdriver
■
Related Information
"Preparing for Service"
■
"Servicing CRUs That Do Not Require Server Power-Off"
■
"Servicing CRUs That Require Server Power-Off"
■
"Servicing FRUs"
■

Preparing the Server for Component Replacement

Note -
are necessary. See the replacement procedures for those components for more information.
Before you can remove and install components that are inside the server, you must perform the
procedures in the following sections:
"Powering Down the Server" on page 55
■
"Disconnect Cables From the Server" on page 60
■
"Extend the Server to the Maintenance Position" on page 61
■
"Remove the Server From the Rack" on page 63
■
54 Oracle Server X5-2L Service Manual • May 2015
Only one of the quorum members can be replaced at a time. Automated updates can only
When you are replacing the storage drives or power supplies, not all of these procedures