Oracle X5-2L Service Manual page 232

Return the Server to the Normal Rack Position
FIGURE 90
Continue pushing the server into the rack until the slide-rail locks (on the
b.
front of the server) engage the slide-rail assemblies.
You will hear an audible click when the server is in the normal rack position.
2. If the CMA is not installed, that is, you removed it because you removed the
server completely out of the rack, install the CMA.
For installation instructions for the CMA, refer to
"Oracle Server X5-2L Installation Guide
3. If the cables are disconnected from the rear of the server, that is, you
disconnected the cables because you extended the server out of the rack,
reconnect the cables.
For instructions on reconnecting cables to the rear of the server, see
■
Data Cables" on page
For detailed information on connecting cables to the rear of the server, refer to
■
Connections and Ports" in "Oracle Server X5-2L Installation Guide
232 Oracle Server X5-2L Service Manual • May 2015
Location of the Release Tabs on the Slide-Rails
".
233.
"Install the Cable Management Arm" in
"Reconnect Power and
".
"Rear Cable