Install Nvme Cables - Oracle X5-2L Service Manual

Carefully remove the NVMe cable bundle from the chassis mid-wall. Be careful not to snag the
cables on the server components.
Related Information
"Install NVMe Cables" on page 177
■

Install NVMe Cables

Install the NVMe cables between the front storage drive backplane and the
1.
Oracle PCIe NVMe switch card in PCIe slot 3.
Route the NVMe cable bundle through the chassis mid-wall and via the cable trough between
the fan modules and processors.
Reconnect the NVMe cables to the front storage drive backplane [1].
2.
Plug each cable into its connector until you hear an audible click.
The following figure shows NVMe cables being installed in the twenty-four drive
Note -
system configuration. If you are installing NVMe cables in an eight-drive system configuration,
your front disk backplane NVMe connector locations will be different.
Install NVMe Cables
Servicing FRUs 177