Oracle X5-2L Service Manual page 81

# hotplug list –lc
Connection State
Path
------------------------------------------------------------------
pcie13 EMPTY
Install an NVMe Storage Drive in the Server
Perform this procedure to physically install an NVMe storage drive into the server.
Note - After you physically remove an NVMe storage drive from the server, wait at least 10
seconds before installing a replacement drive.
1. Remove the replacement drive from its packaging and place the drive on an
antistatic mat.
2. If necessary, remove the drive filler panel.
3. Align the replacement drive with the drive slot.
The drive is physically addressed according to the slot in which it is installed. It is important to
install a replacement drive in the same slot as the drive that was removed.
4. Slide the drive into the slot until the drive is fully seated.
See Figure 17.
Close the drive latch to lock the drive in place.
5.
Power On an NVMe Storage Drive and Attach a Device Driver
Type: #
1.
hotplug enable pcie13
Type: #
2.
hotplug list –lc
The following status is displayed for the NVMe storage drive.
# hotplug list –lc
Connection State
Path
------------------------------------------------------------------
pcie13 Enabled PCIe-Native /pci@7a,0/pci8086,2f08@3/pci111d,80b5@4
3. To check the NVMe drive health, firmware level, temperature, get error log,
SMART data, security erase, low level format, etc., type:
#
nvmeadm list
Description
PCIe-Native /pci@7a,0/pci8086,2f08@3/pci111d,80b5@4
Description
Servicing CRUs That Do Not Require Server Power-Off
Install an NVMe Storage Drive in the Server
81