Remove The Storage Drive Backplane For Twenty-Four Drive Systems - Oracle X5-2L Service Manual

Remove the Storage Drive Backplane for Twenty-Four Drive Systems

Related Information
"Remove the Storage Drive Backplane for Twelve-Drive Systems" on page 152
■
Remove the Storage Drive Backplane for Twenty-
Four Drive Systems
1. Prepare the server for service.
Power off the server and disconnect the power cords from the power
a.
supplies.
See
b. Extend the server into the maintenance position.
See
c. Attach an antistatic wrist strap to your wrist, and then to a metal area on the
chassis.
See
d. Open the server fan assembly door, and remove the fan modules from the
server.
See
e. Remove the fan assembly door from the server.
See
2. Pull each storage drive out far enough to disengage it from the disk backplane.
See "Remove an HDD or SSD Storage Drive" on page
Note -
them out far enough to disengage them from the disk backplane. If you do remove the storage
drives from the server, make a note of their locations so that you can reinstall them in the same
locations.
3. Disconnect the cables from the storage drive backplane.
a. Disconnect the two power cables and the auxiliary signal cable from the
storage drive backplane [1].
158 Oracle Server X5-2L Service Manual • May 2015
"Powering Down the Server" on page
"Extend the Server to the Maintenance Position" on page
"Take Antistatic Measures" on page
"Remove a Fan Module" on page
"Remove the Fan Assembly Door From the Server" on page
It is not necessary to completely remove the storage drives from the server; simply pull
55.
61.
64.
89.
73.
65.