Remove the Disk Cage Cover From the Server
Before you service the server's storage drive backplane, you should first remove the server's
disk cage cover.
This procedure is only required for systems configured with eight 2.5-inch storage
Note -
drives. If your system is configured with twelve 3.5-inch storage drives or twenty-four 2.5-inch
storage drives, see
1.
Ensure that the AC power cords are disconnected from the server power
supplies.
2.
Using a No. 2 Phillips screwdriver, remove the twelve screws (three on each top
side of the chassis, and three on each side of the chassis) that secure the disk
cage cover [1].
"Remove the Fan Assembly Door From the Server" on page
Remove the Disk Cage Cover From the Server
Preparing for Service
65.
67
Need help?
Do you have a question about the X5-2L and is the answer not in the manual?