Servicing The Internal Usb Flash Drives (Cru) - Oracle X5-2L Service Manual

See
c. Return the server to the normal rack position.
See
Connect any required data cables to the PCIe card.
d.
Route data cables through the cable management arm.
Reconnect the power cords to the power supplies and power on the server.
e.
See
Server" on page
Use Oracle ILOM to clear any server PCIe card faults.
7.
If a PCIe card fault message in Oracle ILOM is not cleared under Open Problems, you
must manually clear the fault in Oracle ILOM. For instructions for manually clearing a
PCIe card fault, see the procedure "Clear Faults for Undetected Replaced or Repaired
Hardware Components" in the Oracle ILOM User's Guide for System Monitoring and
Diagnostics Firmware Release 3.2.x in the Oracle Integrated Lights Out Manager (ILOM) 3.2
Documentation Library at http://www.oracle.com/goto/ILOM/docs.
8. To determine wheather additional steps are required to complete the installation
of the PCIe card, refer to the server product notes for the type of PCIe card you
installed.
For a complete listing of the PCIe host bus adapter (HBA) cards supported by the server, refer
to the Oracle Server X5-2L Product Notes at http://www.oracle.com/goto/X5-2L/docs.
Related Information
"PCIe Slot Locations" on page 116
■
"Remove a PCIe Card" on page 117
■

Servicing the Internal USB Flash Drives (CRU)

Caution -
to electrostatic discharge. This sensitivity can cause the component to fail. To avoid
damage, ensure that you follow antistatic practices as described in
Measures" on page
"Install the Server Top Cover" on page
"Return the Server to the Normal Rack Position" on page
"Reconnect Power and Data Cables" on page 233
233. Verify that the AC OK LED is lit.
These procedures require that you handle components that are sensitive
64.
Servicing the Internal USB Flash Drives (CRU)
226.
231.
and "Power On the
"Take Antistatic
Servicing CRUs That Require Server Power-Off 121