Bios Advanced Menu Iscsi Configuration Options - Oracle X5-2L Service Manual

BIOS Advanced Menu Selections
Setup Options
Static IPv6 Address (R/O)
Commit
BIOS Advanced Menu iSCSI Configuration
Options
The following table describes the BIOS Advanced Menu iSCSI configuration options.

BIOS Advanced Menu iSCSI Configuration Options

TABLE 32
Setup Options
iSCSI Initiator Name
Add an Attempt
iSCSI Attempt Name
iSCSI Mode
Internet Protocol
282 Oracle Server X5-2L Service Manual • May 2015
Options
Options
NA (must be specified)
NA (must be specified)
Disabled/Enabled/Enabled for
MPIO
IP4/IP6/Autoconfigure
Defaults
Defaults
None
None
Disabled
IP4
Description
■ Stateless: When enabled,
the IPv6 Stateless
autoconfiguration is run to
learn the IPv6 addresses for
the device.
■ Dhcpv6_stateless:
When enabled, the
Dhcpv6_stateless
autoconfiguration is run to
learn the DNS and domain
information for the device.
■ Dhcpv6_stateful: When
enabled, the Dhcpv6_stateful
autoconfiguration is run to
learn the IP addresses and
DNS information for the
device.
Set the static IPv6 address.
Example: 2001:0db0:000.82a1:
0000:0000:1234:abcd
Commit the current BMC LAN
information.
Description
The worldwide unique name of
the iSCSI Initiator. Only IQN
format is accepted.
The readable name that you
assigned to this attempt.
Set to Enabled for multipath I/
O (MPIO). MPIO can boost the
performance of an application
by load balancing traffic across
multiple ports.
Can be set to IP4, IP6, or
Autoconfigure. The initiator
IP address is assigned by the
system to IP6. In Autoconfigure
mode, the iSCSI driver attempts