Crp Configuration; Enabling The Crp Application - AudioCodes Mediant 4000 SBC User Manual

User's Manual
30

CRP Configuration

This section describes configuration specific to the CRP application. As CRP has similar
functionality to the SBC application, for configuration that is common to the SBC, which is
not covered in this section, see the following SBC sections:

''Configuring Admission Control'' on page 451

''Configuring Allowed Audio Coder Groups'' on page 380

''Configuring Classification Rules'' on page 455

''Configuring Message Condition Rules'' on page 463

''Configuring SBC IP-to-IP Routing Rules'' on page 464

''Configuring SIP Response Codes for Alternative Routing Reasons'' on page 476

''Configuring IP-to-IP Inbound Manipulations'' on page 485

''Configuring IP-to-IP Outbound Manipulations'' on page 489
Note:
applications is the navigation menu paths to opening these Web configuration pages.
Wherever "SBC" appears in the menu path, for the CRP application it appears as
"CRP".
30.1

Enabling the CRP Application

Before you can start configuring the CRP, you must first enable the CRP application. Once
enabled, the Web interface displays the menus and parameter fields relevant to the CRP
application.
Note:
that includes this feature. For installing a License Key, see ''License Key'' on page
581.

To enable the CRP application:
1. Open the Applications Enabling page (Setup menu > Signaling & Media tab > Core
Entities folder > Applications Enabling).
2. From the 'CRP Application' drop-down list, select Enable.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
Version 7.2
The main difference in the common configuration between the CRP and SBC
The CRP feature is available only if the device is installed with a License Key
535
30. CRP Configuration
Mediant 4000 SBC