Chapter 2
7) Clean around the host machine.
2.6 Installing the Card Reader
2.6.1 Notice At Installation
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
- Installation of the equipment calls for a Card Reader Attachment-B3.
- See "Combination Table of Accessories" when installing this equipment.
2.6.2 Checking the Contents
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
<Card Reader-C1>
[1]
[1]
Card reader
[2]*
Screw (RS tightening; M4X10)
[3]*
Toothed washer
* Not used in this host machine.
<Card Reader Attachment-B3>
2-18
[1]
F-2-70
[2]
[3]
F-2-71
1 pc.
1 pc.
1 pc.
[1]
[3]
0019-5419
[5]
[1]
Card reader attachment base
[2]*1
Card reader support plate
[3]*1
Relay harness1
[4]
Relay harness2
0018-9070
[5]
Screw (TP; M4X25)
[6]*2
Screw (TP; M4X8)
[7]
Toothed washer
*1 Not used in this host machine.
*2 1pc is used with this host machine.
2.6.3 Turning OFF the Power of the Host Machine
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Be sure to refer to "Points to Note When Turning OFF the Main Power" in
installation of the host machine.
2.6.4 Installation Procedure
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
After the card reader is installed, go through the following in Service Mode
of this machine: COPIER > FUNCTION > INSTALL > CARD, and enter
the card number to use. Be sure to enter the card number otherwise the card
is not recognized when the card is inserted.
1) Open the cassette upper right cover [1]. If the cassette pedestal is installed,
open the cassette lower right cover [2].
1
[6]
2
F-2-72
[2]
1
[4]
[7]
1pc
1pc
1pc
1pc
1pc
2pc
2pc
0018-9072
0018-9173