Installing The System Software (Sst -> Usb) - Canon iR3245 Series Service Manual

Hide thumbs Also See for iR3245 Series:
Table of Contents

Advertisement

18.2.2 Installing the System Software (SST -> USB)
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Here, you will be copying the system software from the SST to a USB device.
Preparatory Work
Preparation:
- PC installed with SST version 4.02 or later
- USB device (*)
*: USB Requirements
Interface:
Capacity:
Format:
You cannot use a security-protected USB device. Be sure to remove the protection before use.
Copying the System Software
1) Start up the PC.
2) Connect the USB device to the USB port of the PC.
3) Start up the SST.
4) Click the USB icon on the Target Selection screen.
5) Select the drive (removable disk drive) to which the USB device has been connected.
USB 1.1 or higher (USB 2.0 or recommended)
1 GB or more recommended (A set of system software is in excess of 512 MB.)
FAT (FAT16), FAT32 (It must not be NTFS or HFS.)
single partition (There must not be multiple partitions.)
Service Support Tool DLM0 (Ver. X.XX E)
Target Selection
CONTROL
Select the target.
Click a button to execute.
MFP
MFP
USB
USB
S y s t e m M a n a g e m e n t
c:
Service Support Tool DLM0 (Ver. X.XX E)
Target Selection
CONTROL
Select the target.
Click a button to execute.
MFP
MFP
USB
S y s t e m M a n a g e m e n t
USB
c:
Select the destinate drive.
Model List
Select a model to connect
CONNECT
R e g i s t e r F i r m wa r e
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
ST
STAR
ART
S t a r t A s s i s t M o d e
EXIT
F-18-8
Export Firm Selection
Select the destinate drive.
Series
E x p o r t F i r m wa r e
Version
R e g i s t e r F i r m wa r e
Firmware registration status
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
START
CANCEL
EXIT
F-18-9
Chapter 18
0019-6415
18-7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3225 series3230 series3235 series

Table of Contents