Sensor Mount - Canon iR3245 Series Service Manual

8.8.4 Sensor Mount

8.8.4.1 Before Removing the Sensor Mounting Plate
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
1) Remove the rear right cover. (page 10-16)Reference[Removing the
Rear Right Cover]
2) Release the right cover. (page 10-36)Reference[Releasing the Right
Cover]
3) Remove the right cover (lower front). (page 10-16)Reference[Remov-
ing the Right Cover (Lower Front)]
4) Remove pickup unit 1. (page 8-30)Reference[Removing the Pickup
Unit 1]
5) Remove pickup unit 2. (page 8-30)Reference[Removing the Pickup
Unit 2]
8.8.4.2 Removing the Sensor Mounting Plate
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
1) Remove the 2 TP screws [1] and the binding screw [2] at the rear of the
pickup assembly to remove the bracket [3].
Pickup unit 1
Pickup unit 2
F-8-36
F-8-37
2) Disconnect the connector [1] and remove the screw [2] to remove the cas-
sette pickup solenoid [3].
3) Remove the bushing [4] and the 5 screws [5] to remove the sensor mount-
ing plate [6].
0018-9815
0018-9816
8.8.4.3 Attaching the Sensor Mounting Plate
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Be sure not to make the pickup unit facing downward when attaching the
sensor mounting plate because the gears can fall.
1) Fit the 6 points [A] shown in the figure into the holes of the sensor mount-
ing plate [1], and then tighten with 5 screws to attach the sensor mounting
plate [1].
2) Attach the cassette pickup solenoid [1].
Be sure to make the baffle [2] engaged with the cam gear [3].
F-8-38
[A]
[1]
F-8-39
F-8-40
Chapter 8
0018-9817
8-31