If the System manager ID and system password have already been assigned, ID Entry dialog appears after System Settings button is pressed. Enter the system manager
ID and the password, and click ID key to go into System Management Mode.
2) Make the following selections: [MEAP Settings] button > [Use HTTP] button> [On] button > [OK] button .
MEMO:
When using SSL, set [Use SSL] ON.
(This setting is also applied to the SSL setting of RUI. Same is true in the case of setting SSL ON on the side of RUI.)
Setting [Use SSL] ON displays the message dialogue 'Changes effective after the main power switch is turned OFF and ON' . Press [OK].
3) Press Done button as many times as necessary until the Basic screen appears.
4) Turn off the device's main power; wait for 10 sec, and then turn the power back on.