Canon iR3245 Series Service Manual page 561

Item Level Description
2TR-TGT7 2 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/
Operation method
Relevant Service Mode
Supplementary info/Memo
2TR-TGT8 2 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/
Operation method
Relevant Service Mode
Supplementary info/Memo
TR-PPR1 2 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/
Operation method
Relevant Service Mode
Supplementary info/Memo
TR-PPR2 2 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/
Operation method
Relevant Service Mode
Supplementary info/Memo
COPIER > ADJUST > HV-TR
Offset adjustment for secondary transfer target current
In case of image fault due to secondary transfer
Set the conditions for material, environment, and 2-sided printing in the relevant service mode and
adjust the offset value under these conditions.
-10 to +10
uA
-
0/No
1) Select the item to be highlighted to enter the setting value (switch with +/- key), and then press OK
key.
2) Turn OFF and then ON the main power switch.
- Increase the setting value (effective for toner spatter, dotted image)
- Decrease the setting value (effective for white dot/white spot/granulated image at halftone)
COPIER > ADJUST > HV-TR > TR-PPR7
COPIER > ADJUST > HV-TR > TR-ENV7
COPIER > ADJUST > HV-TR > TR-DUP7
-
Offset adjustment for secondary transfer target current
In case of image fault due to secondary transfer
Set the conditions for material, environment, and 2-sided printing in the relevant service mode and
adjust the offset value under these conditions.
-10 to +10
uA
-
0/No
1) Select the item to be highlighted to enter the setting value (switch with +/- key), and then press OK
key.
2) Turn OFF and then ON the main power switch.
- Increase the setting value (effective for toner spatter, dotted image)
- Decrease the setting value (effective for white dot/white spot/granulated image at halftone)
COPIER > ADJUST > HV-TR > TR-PPR8
COPIER > ADJUST > HV-TR > TR-ENV8
COPIER > ADJUST > HV-TR > TR-DUP8
-
Paper type item at secondary transfer offset adjustment
Paper type item at secondary transfer offset adjustment
-
1: plain paper, 2 thick paper, 3: envelope, 4: tracing paper, 5: transparency, 6: postcard, 7: label paper,
8: bond paper
-
-
1/No
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
COPIER > ADJUST > HV-TR > TR-TGT1
-
Paper type item at secondary transfer offset adjustment
Paper type item at secondary transfer offset adjustment
-
1: plain paper, 2 thick paper, 3: envelope, 4: tracing paper, 5: transparency, 6: postcard, 7: label paper,
8: bond paper
-
-
1/No
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
COPIER > ADJUST > HV-TR > TR-TGT2
-
Chapter 17
17-63