Canon iR3245 Series Service Manual page 543

Item Level Description
DFTAR-R 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
DFTAR-G 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
DFTAR-B 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
CCD-CHNG 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
COPIER > ADJUST > CCD
Shading target value (RED) entry when using DF (normal document scanning position)
In case of image fault (due to chart soil, etc) after executing: COPIER > FUNCTION > CCD > DF-
WLVL1/DF-WLVL2; enter the factory measurement value using this mode.
-
1 to 2047
-
-
1159/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
COPIER > FUNCTION > CCD > DF-WLVL1 (Level 1)
COPIER > FUNCTION > CCD > DF-WLVL2 (Level 1)
-
Shading target value (GREEN) entry when using DF (normal document scanning position)
In case of image fault (due to chart soil, etc) after executing: COPIER > FUNCTION > CCD > DF-
WLVL1/DF-WLVL2; enter the factory measurement value using this mode.
-
1 to 2047
-
-
1189/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
COPIER > FUNCTION > CCD > DF-WLVL1 (Level 1)
COPIER > FUNCTION > CCD > DF-WLVL2 (Level 1)
-
Shading target value (BLUE) entry when using DF (normal document scanning position)
In case of image fault (due to chart soil, etc) after executing: COPIER > FUNCTION > CCD > DF-
WLVL1/DF-WLVL2; enter the factory measurement value using this mode.
-
1 to 2047
-
-
1209/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
COPIER > FUNCTION > CCD > DF-WLVL1 (Level 1)
COPIER > FUNCTION > CCD > DF-WLVL2 (Level 1)
-
CCD replacement flag
Set this mode when CCD replacement is completed.
-
0 to 1
-
-
0/No
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
-
-
Chapter 17
17-45