- The status of the license must be 'Not Installed' or 'Unnecessary' for its application to be uninstalled. As necessary, go to License File Management page, and disable

the license file before starting to remove it.

- Dimmed [Uninstall] button shows that the selected application cannot be removed.

- A license file may be invalidated only when its application is not active.

- If the application you are uninstalling is associated with another application, a message will appear to indicate that the package exported by the application will no

loner be available. Uninstalling such an application may also disable its associated applications.

1) Log on to SMS, and click [Application List] tab.

2) Check [Application List] page appears.

3) On the application list, select the radio button of the application you want to uninstall, and click [Uninstall] button.

4) Check the screen to make sure that what is shown is the application you want to uninstall; then, click [OK] button.

In response, the system runs an uninstall sessions.

11.1.23 Login Service

iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N

The login service is used to authenticate the user when a MEAP device is booted up. Login service changes and install/ uninstall are carried out from the 'System

Management' page.

The pre-install applications and those provided on the accessory CD are as follows. Default Authentication is used as the default at the time of shipment from the

factory.

Pre-install

Accessory CD

- When the login service is set to SSO-H, Department ID management needs to be [OFF] before changes can be made. To use SSO-H local device authentication and

Department ID management at the same time, after allocation of the department ID to the Administrator, switch the authentication method to local device

authentication and then turn Department ID management ON.

- To use Department ID management in domain authentication, the option imageWARE accounting manager is required.

- When the setting is SSO-H, the card reader for the option controller card cannot be used.

- When using SSO-H, the clock settings of the server managing the Active Directory and the MEAP device (and the PC used to log in), must be matched. If there is

a time difference of greater than five minutes in the clock settings, an error will be generated when login is attempted.

- When the setting is SSO-H, start up takes a little longer when compared to Default Authentication (because of the time required for object initialization).

- To use the SEND function when the setting is for SSO-H, when sending email, mail addresses need to be programmed against each user. If they are not, email

cannot be sent. Note, however, that when sending i-Fax, the mail addresses set in the device are used.

Other than iR3245

Default Authentication(default)

Simple Device Login

Single Sign On

Default Authentication

Simple Device Login

Single Sign On and Security Agent

F-11-50

T-11-18

iR3245

Default Authentication (default)