Canon iR3245 Series Service Manual page 628

Chapter 17
The value which has been set takes effect after the main power switch has been turned OFF and back ON.
Item Level
PROXYRES 2
FIX-PROT 1
FIX-OFST 1
17-130
COPIER > OPTION > BODY
Description
Title Switch for selecting whether to provide a proxy response to inquiries from Windows
Purpose of use, When used This item is used not to provide a proxy response so that accurate status responses are provided for
inquiries from Windows during sleep mode.
Precautions for use -
Settings and adjustment 0: A proxy response is not provided. 1: A proxy response is provided.
ranges
Unit -
Value at time of shipment 1
from factory/Value
established when RAM is
cleared
Setting, adjustment and 1) Select the item to highlight it, input the setting, and press the OK key.
operation procedures 2) Set the main power switch to OFF and back to ON.
Related service modes -
Additional description and -
notes
Title Mode of measures for jams of paper absorbing moisture
Purpose of use, When used This item is used when jams occur in paper absorbing moisture.
Precautions for use -
Settings and adjustment 0: OFF 1: ON
ranges The mode of measures for jams of paper absorbing moisture (initial rotation period is specified to be
longer than the normal period) becomes valid when all the following conditions are satisfied.
- FIX-PROT="1"
- FIX-TEMP=-10degC or -20degC
- The room temperature is higher than 21degC.
Unit -
Value at time of shipment 0
from factory/Value
established when RAM is
cleared
Setting, adjustment and 1) Select the item to highlight it, input the setting, and press the OK key.
operation procedures 2) Set the main power switch to OFF and back to ON.
Related service modes -
Additional description and -
notes
Title Mode of measures for dirt on fixing film
Purpose of use, When used When a small number of large-size sheets passed through the machine after small-size sheets
continuously passed through, dirt occurs on the edge of film, which may cause the life of fixing film
to be shortened. To prevent this symptom, this mode is used to stop feed operation of subsequent sheets
until the fixing sub thermistor detection temperature becomes lower than the specified temperature.
Precautions for use Productivity may decrease depending on the degree of temperature increase on the edge.
Settings and adjustment 0: Start passing sheets at 240degC or less.
ranges 1: Start passing sheets at 180degC or less.
2: Start passing sheets at 190degC or less.
3: Start passing sheets at 200degC or less.
This setting becomes valid when all of the following conditions are satisfied.
- FIX-OFST="1"
- When the small-size paper is switched to the large-size paper, the difference of temperature between
the fixing main thermistor and the sub thermistor is higher than the specified temperature.
Unit -
Value at time of shipment 0
from factory/Value
established when RAM is
cleared
Setting, adjustment and 1) Select the item to highlight it, input the setting, and press the OK key.
operation procedures 2) Set the main power switch to OFF and back to ON.
Related service modes -
Additional description and -
notes