Ccd Hp Sensor; Removing The Ccd Unit Hp Sensor; Original Size Sensor; Removing The Original Size Sensor - Canon iR3245 Series Service Manual

Chapter 5

5.4.8 CCD HP Sensor

5.4.8.1 Removing the CCD Unit HP Sensor

iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
1)Remove the copyboard glass.
2)Remove the ADF reading glass.
3)Pull the drive belt [1] in the direction of the arrow and move the CCD [2]
to the position shown in the figure.
[1]
4)Remove the CCD unit HP sensor [1].
-1 connector [2]
When removing the sensor, it is good to push inward the claw [3] at the rear
side.
[2]
[1]

5.4.9 Original Size Sensor

5.4.9.1 Removing the Original Size Sensor

iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
5-26
[2]
F-5-50
[3]
F-5-51
1)Remove the ADF communication cable (only for machine with ADF in-
stalled).
2)Open the copyboard cover (platen board cover/ADF).
3)Remove the reader rear cover.
4)Remove the copyboard glass.
0019-6915
5)Remove the cable retainer [1] and the sensor cover [2].
-2 screws [3]
6)Remove the hook [1] and the original size sensor [2].
7)Turn the sensor cover around and remove the connector [2] of the original
size sensor [1].
0019-4792
[1]
[2]
F-5-52
[2]
[1]
F-5-53
[3]
[2]
[1]
F-5-54
[3]