2) Remove the gear [2] and the cam [4] (releasing the claws [1, 3]).
[1]
[2]
[3]
[4]
3) Remove the following parts.
- 6 wire saddles [1] (removing the harness)
- 2 edge saddles [2] (removing the harness)
- 1 reuse band [3]
- 4 fastons [4]
- 6 connectors [5]
[5]
[1]
[1]
[5]
[4]
F-10-49
[5]
[2]
[2]
[3]
[5]
F-10-50
4) Remove the 4 screws [2] and remove the main drive unit [1].
Do not touch the screws that are glued in place.
[2]
[2]
Points to Note At Installation
Be sure to fit the fastons of the appropriate colors and install them as shown
in the following figure.
[WH]
[WH]
Chapter 10
[2]
[1]
[2]
F-10-51
[BK]
[BK]
10-23