Canon iR3245 Series Service Manual page 548

Chapter 17
Item Level
MTF3-S8 1
MTF3-S9 1
MTF3-S10 1
MTF3-S11 1
MTF3-S12 1
17-50
COPIER > ADJUST > CCD
Description
Title MTF setting value for B in vertical scanning direction (center)
Purpose Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
Note -
Settings/Adjustment range 20 to 80
Unit -
Amount of change per unit -
Value at RAM clear/ 55/Yes
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value, and then press OK key.
method 2) Turn OFF and then ON the main power switch.
Relevant Service Mode -
Supplementary info/Memo -
Title MTF setting value for B in vertical scanning direction (rear)
Purpose Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
Note -
Settings/Adjustment range 20 to 80
Unit -
Amount of change per unit -
Value at RAM clear/ 55/Yes
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value, and then press OK key.
method 2) Turn OFF and then ON the main power switch.
Relevant Service Mode -
Supplementary info/Memo -
Title MTF setting value for K in vertical scanning direction (front)
Purpose Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
Note -
Settings/Adjustment range 20 to 80
Unit -
Amount of change per unit -
Value at RAM clear/ 55/Yes
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value, and then press OK key.
method 2) Turn OFF and then ON the main power switch.
Relevant Service Mode -
Supplementary info/Memo -
Title MTF setting value for K in vertical scanning direction (center)
Purpose Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
Note -
Settings/Adjustment range 20 to 80
Unit -
Amount of change per unit -
Value at RAM clear/ 55/Yes
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value, and then press OK key.
method 2) Turn OFF and then ON the main power switch.
Relevant Service Mode -
Supplementary info/Memo -
Title MTF setting value for K in vertical scanning direction (rear)
Purpose Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
Note -
Settings/Adjustment range 20 to 80
Unit -
Amount of change per unit -
Value at RAM clear/ 55/Yes
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value, and then press OK key.
method 2) Turn OFF and then ON the main power switch.
Relevant Service Mode -
Supplementary info/Memo -