Canon iR3245 Series Service Manual page 477

XX YY
The HDD cannot be recognized. The startup partition (BOOTDEV)
cannot be found at startup.
01
00
The system software for the main CPU does not exist.
02
Suspension of a write operation to the boot device has been detected. 1. Start in safe mode, reinstall a system, and turn OFF/ON the power.
03
The system software of the sub CPU does not exist.
06
XX= "01" to "FF"
CHK-
XX Partition
TYPE
01 FSTDEV
02 1 IMG_MNG
03 FSTCDEV
04 APL_GEN
05 TMP_GEN
2
06 TMP_FAX
07 TMP_PSS
08 3 PDLDEV
09 4 BOOTDEV
10 5 APL_MEAP
11 6 APL_SEND
12 7 APL_KEEP
13 8 APL_LOG
FF 0 not specified
[HDD formatting]
XX CHK Partition in
- question
TYP
E
01 1 DOSDEV
02 1 FSTDEV
03 1 DOSDEV2
04 1 FSTPDEV
05 2 DOSDEV3
06 3 PDLDEV
07 4 DOSDEV4
08 4 BOOTDEV
09 5 DOSDEV5
Description
XX
compressed image data (e.g., Box)
file management table, profile
job archiving (changing)
general-purpose data
general-purpose data (temporary file)
not used
for PDL spool (temporary file)
PDL-related file
firmware (system, MEAP, key, certificate, PDF dictionary, RUI,
content, voice dictionary)
MEAP application
address book, filter
for non-initialization data storage
system log
check for and recovery of HDD full-fault sectors
Description
General data storage area
Image data storage area (e.g., Box)
Image thumbnail display data area (e.g., Box)
Image data storage area (e.g., Box)
General file storage area (user settings, logs,
PDL spool, image data control info)
PDL-related file storage area (font, registered
form, ICC profile, color correction info file for
PDL function)
Firmware storage area (address book, filter)
Firmware storage area (System, Language, RUI) System
For future expansion
T-16-7
1. Turn off the main switch, and check the cable connector. Then, turn on the
main switch.
2. Check to see if the HDD spins up when the main switch is turned on and if the
5V/12V power is supplied.
3. If the symptom still exists after the foregoing, replace the HDD, re-install the
system software. If the symptom still exists, replace the main board.
1. Start in safe mode, reinstall a system, and turn OFF/ON the power.
2. Replace the HDD and reinstall a system.
2. Replace the HDD and reinstall a system.
1. Start in safe mode, reinstall a system, and turn OFF/ON the power.
2. Replace the HDD and reinstall a system.
T-16-8
Description
T-16-9
Typical item HDD formatting by
deleted HD-CLEAR
Entire Possible (4 partitions,
collection of simul-taneously)
image data
(e.g., Box)
Entire Possible (4 partitions,
collection of simul-taneously)
image data
(e.g., Box)
Entire Possible (4 partitions,
collection of simul-taneously)
image data
(e.g., Box)
Entire Possible (4 partitions,
collection of simul-taneously)
image data
(e.g., Box)
Items that are Possible
relatively less
critical
User Font Possible
IccProfil
Address book Not possible
Not possible
software
None in Possible
particular
Remedy
YY
Occurrence at time of Occurrence during
start-up normal execution
00,01,0
03 05 11,21 13,25
2,04
Action Action
*1 *5
*9 *10
*3 *8
*1 *5
*2 *6
*3 *8
*1 *5
*4 *7
Normal mode + Safe mode + HDD
HDD formatting formatting with SST
with SST
Not possible Not possible
Not possible Not possible
Not possible Not possible
Not possible Not possible
Not possible Not possible
Not possible Not possible
Not possible Not possible
Specify the BOOTDEV and perform a format.
System download is required after format.
Not possible Not possible
Chapter 16
10,12,14,
22,23,24
*11 *12
16-9