Copier > Option > Int-Face (2/2) - Canon iR3245 Series Service Manual

Item Level
IMG-CONT 1
When the value is set to 1, the values of the following user mode items return to the standard values of EFI.
- System administration setting > Network setting > TCP/IP setting > IP address setting > IP address
- System administration setting > Network setting > TCP/IP setting > IP address setting > Subnet mask
- System administration setting > Network setting > TCP/IP setting > IP address setting > Gateway address
- System administration setting > Network setting > TCP/IP setting > Ethernet driver setting > Communication method
- System administration setting > Network setting > TCP/IP setting > Ethernet driver setting > Ethernet type
- System administration setting > Network setting > TCP/IP setting > Activation time
The following user mode settings are set to OFF.
- System administration setting > Network setting > TCP/IP setting > IP address setting > Use of DHCP
- System administration setting > Network setting > TCP/IP setting > IP address setting > Use of RARP
- System administration setting > Network setting > TCP/IP setting > IP address setting > Use of BOOTP
- System administration setting > Network setting > TCP/IP setting > Ethernet driver setting > Automatic detection
- System administration setting > Network setting > Use of spool function
When the value is set to 3 or 4, the following settings are set to OFF in addition to the items mentioned above.
- System administration setting > Network setting > TCP/IP setting > RAW setting
- System administration setting > Network setting > TCP/IP setting > LPD setting
- System administration setting > Network setting > TCP/IP setting > IPP printing
- System administration setting > Network setting > SMB setting
- System administration setting > Network setting > TCP/IP setting > FTP print setting > Use of FTP print
- System administration setting > Network setting > TCP/IP setting > BMLinkS setting > Use of BMLinkS
- System administration setting > Network setting > NetWare setting > Use of NetWare
Since the items mentioned above do not recover even when you set the value back to '0 (Normal mode)', make the setting again whenever necessary.
17.6.1.26 COPIER > OPTION > INT-FACE (2/2)
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Item Level
AP-OPT 2
COPIER > OPTION > INT-FACE
Description
Title Print server connection setting
Purpose of use Make the connection setting with the print server.
When used At installation
Precautions for use -
Settings and adjustment 0: Normal mode (print server unconnected)
ranges 1: Not in use
2: Not in use
3: Print server connected
4: Not in use
5: Not in use
Unit -
Value established when RAM 0
is cleared
Adjusted/not adjusted at time -
of shipment from factory
Setting, adjustment and 1) Select an item and highlight the display. Then enter the specified value and press [OK] key.
operation procedures 2) Turn OFF/ON the main power switch.
Related service modes -
Additional description and
notes
COPIER > OPTION > INT-FACE
Description
Title Enable/disable print setting from the application (PrintMe) with print server installed
Purpose of use, When used Set whether to enable/disable print setting from the application (PrintMe) with print server installed.
Precautions for use -
Settings and adjustment 0: Print permission with the specified account
ranges 1: Print permission without an account
2: No print permission (Only specified department ID can be printed.)
Unit -
Value at time of shipment 0
from factory/Value
established when RAM is
cleared
Setting, adjustment and 1) Select the item to highlight it, input the setting, and press the OK key.
operation procedures 2) Set the main power switch to OFF and back to ON.
Related service modes -
Additional description and -
notes
T-17-75
T-17-76
Chapter 17
0019-9625
17-163