The SMS login method settings are done by setting the login Start/ Stop via the other login method. In other words, the password authentication Start/ Stop setting

is done by first logging in with RLD authentication, and the RLS authentication Start/ Stop setting is done by first logging in with password authentication. The

Start/ Stop combinations of the two login methods are as follows.

Start Password Authentication

Stop Password Authentication

If only login via RLS is programmed, login may be disabled for the following reasons.

- authentication server is down

- network problem, no communication with authentication server

In the event of either of these cases, try the following.

1. If local device authentication is active, try logging in with local device authentication.

2. If only domain authentication is active, launch in MEAP safe mode from the device service mode.

After launching in MEAP safe mode, the Default Authentication will become active, and you will be able to login to SMS with password authentication.

After logging into SMS, set the password authentication login to ON (active) and restore the device from MEAP safe mode to normal mode. Until the problem

blocking authentication is resolved, log into SMS with password authentication.

Setting for login by Password Authentication

The procedures for changing the password authentication Start/ stop settings are as follows.

1) Access SMS by RLS Authentication from the PC browser on the same network as the MEAP device.

URL: http://<IP address of MEAP device>:8000/sms/rls/

Ex.) http://172.16.188.240:8000/sms/rls

11-8

F-11-6

T-11-12

Start RLS Authentication

Stop RLS Authentication

Setting unavailable