Canon iR3245 Series Service Manual page 601

The value which has been set takes effect after the main power switch has been turned OFF and back ON.
Item Level Description
HUM-SW 2 Title
Purpose of use, When used
Precautions for use
Settings and adjustment
ranges
Unit
Value at time of shipment
from factory/Value
established when RAM is
cleared
Setting, adjustment and
operation procedures
Related service modes
Additional description and
notes
SCANSLCT 2 Title
Purpose of use, When used
Precautions for use
Settings and adjustment
ranges
Unit
Value at time of shipment
from factory/Value
established when RAM is
cleared
Setting, adjustment and
operation procedures
Related service modes
Additional description and
notes
PASCAL 1 Title
Purpose of use, When used
Precautions for use
Settings and adjustment
ranges
Unit
Value at time of shipment
from factory/Value
established when RAM is
cleared
Setting, adjustment and
operation procedures
Related service modes
Additional description and
notes
COPIER > OPTION > BODY
Selection of the level of transfer current output by the environment sensor
Use this item when a failure occurs to the environment sensor. The output level of transfer current is
controlled in accordance with the specified environment.
-
0: Automatic control by the environment sensor
1: Low humidity
2: Rather low humidity
3: Normal humidity
4: Rather high humidity
5: High humidity
Make the setting in accordance with the installation environment. The transfer current output level is
controlled in accordance with the specified environment.
Low-humidity environment: The transfer current output level increases.
High-humidity environment: The transfer current output level decreases.
-
0
1) Select the item to highlight it, input the setting, and press the OK key.
2) Set the main power switch to OFF and back to ON.
-
-
ON/OFF of the function to calculate the scanned area from the selected paper size
Make ON/OFF setting of the function to calculate the scanned area from the selected paper size.
If "1" is set when the paper size is larger than the document size, the scanned area increases and
productivity decreases.
0: OFF (The scanned area is determined based on the document size detected.)
1: ON (The scanned area is determined based on the paper size.)
-
0
1) Select the item to highlight it, input the setting, and press the OK key.
2) Set the main power switch to OFF and back to ON.
-
-
Selection of whether or not to use the contrast potential and gradation correction data calculated by
automatic gradation correction control
Select whether or not to use the contrast potential and gradation correction data calculated by
automatic gradation correction control.
-
0 to 3
-
0
1) Select the item to highlight it, input the setting, and press the OK key.
2) Set the main power switch to OFF and back to ON.
-
-
Chapter 17
17-103