Canon iR3245 Series Service Manual page 629

The value which has been set takes effect after the main power switch has been turned OFF and back ON.
Item Level Description
WOLTRANS 1 Title
Purpose of use, When used
Precautions for use
Settings and adjustment
ranges
Unit
Value at time of shipment
from factory/Value
established when RAM is
cleared
Setting, adjustment and
operation procedures
Related service modes
Additional description and
notes
TCPDLACK 1 Title
Purpose of use, When used
Precautions for use
Settings and adjustment
ranges
Unit
Value at time of shipment
from factory/Value
established when RAM is
cleared
Setting, adjustment and
operation procedures
Related service modes
Additional description and
notes
802XTOUT 1 Title
Purpose of use, When used
Precautions for use
Settings and adjustment
ranges
Unit
Value at time of shipment
from factory/Value
established when RAM is
cleared
Setting, adjustment and
operation procedures
Related service modes
Additional description and
notes
IKERETRY 1 Title
Purpose of use, When used
Precautions for use
Settings and adjustment
ranges
Unit
Value at time of shipment
from factory/Value
established when RAM is
cleared
Setting, adjustment and
operation procedures
Related service modes
Additional description and
notes
COPIER > OPTION > BODY
Setting of the protocol for recovery from sleep mode
Determine the protocol for recovery from sleep mode based on the WOL(Wake On LAN)trans value.
-
1: wsd&snmp 2: wsd&cpca 3: cpca&snmp
-
1
1) Select the item to highlight it, input the setting, and press the OK key.
2) Set the main power switch to OFF and back to ON.
-
One of the requirements for recovery from sleep mode is to receive a specific network packet.
When the number of network protocols supported by the device increases, this specific network packet
transfers to the network packet supporting a new network protocol.
However, in an environment where the device is actually used, there is a possibility that the existing
network protocol will be used instead of a new network protocol.
Switch for selecting whether to enable/disable the delay acknowledgment function
Select whether to enable/disable the delay acknowledge function. This item is used to disable the delay
acknowledge function when the network data transfer performance level is decreased due to delay
acknowledge in the 10M environment, etc.
-
0 to 1
When this item is set to '0', the delay acknowledge function of TCP is disabled.
-
1
1) Select the item to highlight it, input the setting, and press the OK key.
2) Set the main power switch to OFF and back to ON.
-
-
IEEE802.1X authentication timeout value
This item is used when a response is made from the authentication server at slow or fast timing.
Change the time to wait a response from the authentication server when 802.1X authentication is
performed by the device.
-
10 to 120
-
30
1) Select the item to highlight it, input the setting, and press the OK key.
2) Set the main power switch to OFF and back to ON.
-
-
Number of IKE retries
Set the number of retries when no response is made from the receiver when transmitting IKE packets.
-
0 to 3
Number of retries
2
1) Select the item to highlight it, input the setting, and press the OK key.
2) Set the main power switch to OFF and back to ON.
-
-
Chapter 17
17-131