Canon iR3245 Series Service Manual page 549

Item Level Description
MTF4-M1 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
MTF4-M2 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
MTF4-M3 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
MTF4-M4 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
MTF4-M5 1 Title
Purpose
Note
Settings/Adjustment range
Unit
Amount of change per unit
Value at RAM clear/
adjustment at factory
shipment
Setting/Adjustment/Operation
method
Relevant Service Mode
Supplementary info/Memo
COPIER > ADJUST > CCD
MTF specified value for R in horizontal scanning direction (front)
Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
-
20 to 80
-
-
55/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
-
-
MTF specified value for R in horizontal scanning direction (center)
Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
-
20 to 80
-
-
55/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
-
-
MTF specified value for R in horizontal scanning direction (rear)
Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
-
20 to 80
-
-
55/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
-
-
MTF specified value for G in horizontal scanning direction (front)
Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
-
20 to 80
-
-
55/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
-
-
MTF specified value for G in horizontal scanning direction (center)
Enter the value on the label (included in the package) attached on CCDBOX when replacing
CCDBOX/reader controller PCB (at RCON clear)
-
20 to 80
-
-
55/Yes
1) Select the item to be highlighted to enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power switch.
-
-
Chapter 17
17-51