Chapter 8
[1]
[2]
Adjusting the Tension of the Main Motor
1) Temporarily fix the main motor mounting plate in place to the main drive
unit.
2) So that the motor gear and the teeth of the pulley mesh correctly, move
the motor in the direction of the arrow.
3) Tighten the screws of the main motor mounting plate in the order indicated
([A] -> [B] -> [C] -> [D]).
[B]
[C]
8-38
2) Remove the plate [5].
[2]
[D]
[A]
- 1 edge saddle [1] (removing the harness)
- 1 connector [2]
- 2 screws [3]
- 1 spring [4]
[3]
[5]
F-8-71
Points to Note When Installing the Plate
- Be sure to hook the spring [1] on the plate [2].
- Be sure to hook the spring [1] of the flapper on the end [2] of the unit.
[1]
[2]
[3]
[4]
[1]
[2]