Usb Memory Related Functions(Supported Outside Of Japan And Europe) - Canon iR3245 Series Service Manual

MEMO:
As the driver loaded for the USB device does not toggle dynamically, when any settings changes are made, power must be turned OFF/ ON.
*NB: In the iR3245 models for Europe and Japan, these settings are not displayed. (The display of these settings can be turned on and off in service mode.)

11.1.31 USB memory related functions(supported outside of Japan and Europe)

iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Common spec.
- The file formats supported by the USB memory linkage function are PDF, TIFF and JPEG.. (Saving in XPS format is not supported.)
- When saving an image to USB memory, time stamps and user signatures cannot be added.
- Operation from remote UI and image preview are not supported.
- The only supported USB memory is that which conforms to USB compliance tests.
- USB memory with security settings (passwords, etc.) are not supported.
- USB memory connected via extension cables or USB hubs are not supported.
- While USB memory is connected, the device cannot enter deep sleep.
- While the device is in deep sleep, USB memory cannot be connected.
- The maximum number of files (including folders) that can be displayed in a USB memory is 1,000.
- Non USB memory devices are not supported.
- The default setting permits the use of USB memory.
- If a USB memory device is connected while the device is in deep sleep, the unit will not be able to detect the USB memory, so the USB removal button will not be
displayed (it will be grayed out). Therefore, the USB memory should be removed, then, after touching the control panel and activating the display, reconnect the USB
memory.
- When a MEAP application, etc., is being used, the settings are sometimes not changed. In that case, the following statuses (factory settings) need to be changed in
user mode.
[User mode]>[System administrator settings]>[USB settings]>[Use USB host]: ON
(factory shipment default: ON)
[User mode]>[System administrator settings]>[USB settings]>[Use MEAP driver as USB external memory device]:[OFF]
(factory shipment default: OFF)
Scan to USB memory (supported outside of Japan and Europe)
Scanned documents can be saved directly to USB.
Until a scan job has been completely written into the USB memory, the next scan operation cannot be carried out. In particular, even if a document has been scanned
in, it takes time to write in searchable PDF, etc., so subsequent scanning operations cannot start till the current job has been completely written in.
Box To USB memory (supported outside of Japan and Europe)
Image data stored in box saved to USB memory.
F-11-68
Chapter 11
0019-9234
11-45