Lexmark X940e Service Manual page 669

Step
2
Perform the Skew fine setup printhead adjustment.
Tou ch Cycle result values.
Locate the following new values for the following settings:
Y- Skew adjustment
M- Skew adjustment
C- Skew adjustment
K- Skew adjustment
Turn the appropriate printhead adjustment screws located
behind the waste toner cartridge the number of clicks
(rotation until a snap sound is heard and felt) based on the
above settings.
+values require turning the screw Clockwise
- values require turning the screw Counter Clockwise.
EG: Y-Skew adjustment 10. Turn the screw CW 10 clicks.
EG: Y-Skew adjustment -10. Turn the screw CCW 10 clicks.
Printhead adjusting screw
Have the appropriate printhead adjustment screws been
adjusted?
Check
K C
M
Y
Yes
Perform the In/Out Adjust the
setup. printhead
adjustment screws
"In/out
See
then perform the
setup" on
In/Out setup.
page 4-264.
See "In/out
setup" on
page
Repair information
7510
No
4-264.
4-261