Interconnect Card Assembly Removal - Lexmark X940e Service Manual

Hide thumbs Also See for X940e:
Table of Contents

Advertisement

Interconnect card assembly removal

Warning: In the event of replacement of any one of the following components:
RIP card assembly
Interconnect card assembly
Only replace one component at a time. Replace the required component, and perform a POR before replacing a
second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never
replace two or more of the components listed above without a POR after installing each one, or the printer will be
rendered inoperable.
Warning: Never install and remove components listed above as a method of troubleshooting components. Once a
component has been installed in a machine, it cannot be used in another machine. It must be returned to the
manufacturer.
1. Remove the RIP card assembly. See
Warning: Do not drop the RIP card assembly, or damage will occur.
2. Gently pull the interconnect card assembly (A) from the RIP card assembly (B).
3. Remove the interconnect card assembly (A).
"RIP card assembly removal" on page
A
4-73.
B
Repair information
7510
4-75

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the X940e and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

7510X945e

Table of Contents