Lexmark X940e Service Manual page 544

7510
8. Remove the document tray assembly. See
9. Disconnect connectors P754, P755, P758, P761, P785, and P786 from the ADF controller card assembly (A).
10. Loosen the set screw securing the damper (B) with an Allen wrench.
11. Remove the damper (B).
12. Disconnect the two connections from the switch (ADF left cover interlock) (D) with needle nose pliers.
13. Disconnect the connector from the document set LED (E).
14. Disconnect the connector from the inverter solenoid assembly (F).
15. Release the harness from the three clamps.
16. Remove the two front screws and the five rear screws securing the ADF media feed assembly (G) to the ADF.
17. Release the two harness from the clamp molded into the base of the ADF.
Note: The above clamp is located beneath the ADF registration motor. Do not excessively bend the clamp, or it
may break.
18. Remove the ADF media feed assembly (G) from the ADF.
Note: The plunger in the inverter solenoid assembly (F) will become detached.
Replacement note: Before reinstalling the ADF media feed assembly (G), ensure that the harnesses are
reinserted into their appropriate clamps.
Replacement note: Ensure that the plunger is properly reinserted into the inverter solenoid assembly (F).
Replacement note: Ensure that all connections are properly reconnected.
Replacement note: When replacing the complete ADF media feed assembly, first remove the ADF left cover
assembly and the ADF registration motor from the replacement part.
4-136
Service Manual
"Document tray assembly removal" on page
Connectors
D
F F
Front
Connectors
Clamps
P755
P758 P786
A
P754
P785
P761
E
Set screw
B B
G
Clamp Clamp
Rear
4-137.