Fax/Modem Configuration Id Mismatch; Hard Drive/Configuration Id Mismatch - Lexmark X940e Service Manual

848.00 Fax/modem configuration ID mismatch

Step
1 Check the fax interface card assembly (modem) connection.
Is the fax interface card assembly (modem) connected
properly?
2 Perform a POR.
Does the error remain when the power is turned off/on again?

849.00 Hard drive/configuration ID mismatch

Step
1 Check the hard drive data and power connections.
Are the above connections connected properly?
2 Perform a POR.
Does the error remain when the power is turned off/on again?
900.XX RIP card assembly software error
Step
1 Perform a POR.
Does the error occur when the power is turned off/on?
Check
Check
Check
Yes
Replace the fax Replace the
interface card connection.
assembly
(modem) and
properly set
configuration ID.
Go to "Fax
interface card
(modem)
assembly
removal" on
page 4-74.
Go to
"Configuration
ID" on
page 3-19.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-73.
Yes
Replace the Replace the
hard drive. connections.
Go to "Hard
drive removal"
on page 4-74.
Replace the RIP Problem solved.
card assembly.
"RIP card
Go to
assembly
removal" on
page 4-73.
Yes
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
Diagnostic information
7510
No
No
No
2-131