Sensor (Adf Width Aps 2) Static Jam - Lexmark X940e Service Manual

Step
3
Check the sensor (ADF width APS 1) for proper connection.
Is the above component properly connected?
4
Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
5
Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?

290.22 Sensor (ADF width APS 2) static jam

Step
1
Check the media path.
Is the media path free of media or media fragments?
2 Check the sensor (ADF width APS 2) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF width APS 2.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
3
Check the sensor (ADF width APS 2) for proper connection.
Is the above component properly connected?
4 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Check
Check
Yes
Replace the Replace the
sensor (ADF connection.
width APS 1).
Go to "Sensor
(ADF width APS
1) removal" on
page 4-146.
Replace the ADF Problem solved.
controller card
assembly.
"ADF
Go to
controller card
assembly
removal" on
page 4-138.
Go to step 5.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-73.
Yes
Go to step 2. Remove any
media or media
fragments.
Go to step 4. Go to step 3.
Replace the Replace the
sensor (ADF connection.
width APS 2).
"Sensor
Go to
(ADF width APS
2) removal" on
page 4-147.
Replace the ADF Problem solved.
controller card
assembly.
Go to "ADF
controller card
assembly
removal" on
page 4-138.
Go to step 5.
Diagnostic information
7510
No
No
2-87