Skew - Lexmark X940e Service Manual

7510

Skew

Leading edge
Trailing edge
The printed image is not paralleled with both sides of the media.
Step
1 Check printer installation placement.
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
2
Properly load media into the media tray assembly and
ensure all guides are set correctly.
Properly install the media tray assembly into the printer.
Re-print the defective image.
Does the error continue?
3 Check for obstructions in the area of the media feed
units.
Are the media feed unit assembly free from any
obstructions?
4 Is the printer left door assembly properly and evenly
closed.
5
Check the 2nd transfer roll assembly for contamination
and wear.
Is the 2nd transfer roll assembly free of excess wear
and contamination?
2-228
Service Manual
Check Yes
Go to step 2. Correct the
installation
placement.
Go to step 3. Problem solved.
Go to step 4. Remove
obstructions.
Go to step 5. Open then
properly close
the printer left
door assembly.
Go to step 6. Replace the 2nd
transfer roll
assembly.
Go to
transfer roll
assembly
removal" on
page
No
"2nd
4-35.