Lexmark X940e Service Manual page 562

7510
9. Remove the ADF registration motor. See
10. Remove the ADF media feed assembly. See
11. Remove the ADF feed drive motor assembly. See
12. Lift the separation roll guide assembly to its uppermost position.
13. Remove the actuator/media guide assembly. See
14. Loosen the screw securing the tension bracket (A) and loosen the registration secondary belt (B) tension.
15. Remove the tension spring (B).
16. Loosen the screw securing the small tension bracket (C).
17. Remove the exit roll drive belt (D).
18. Remove the registration secondary drive belt (E).
19. Remove the plastic clip securing the exit/feed-out roll drive pulley 25/28T (F).
20. Remove the exit/feed-out roll drive pulley 25/28T (F).
21. Remove the bearing 8 mm (G) securing the ADF feed-out roll assembly (H) to the rear of the feed assembly.
22. Remove the plastic clip securing the manual feed drive pulley (I).
23. Remove the manual feed drive pulley (I).
24. Remove the manual feed drive belt (J).
25. Remove the bearing 8 mm (K) securing the feed-out roll assembly to the front of the feed assembly.
26. Move the ADF feed-out roll assembly (H) rearward and upward.
27. Remove the ADF feed-out roll assembly (H).
Warning: Do not touch the rubber surface of the ADF exit roll assembly (G).
4-154
Service Manual
"ADF registration motor removal" on page
"ADF media feed assembly removal" on page
A
D
C
H
K
Front
I
Plastic
J
clip
"ADF feed drive motor assembly removal" on page
"Actuator/media guide assembly removal" on page
B
A
E
F
C
Plastic
clip
G
4-159.
4-135.
4-134.
4-152.