Media Damage (Using Adf) - Lexmark X940e Service Manual

Media damage (using ADF)

Leading edge
Trailing edge
Step
1
Properly load document into the ADF unit assembly and
ensure all guides are set correctly.
Re-print the defective image.
Does the error continue?
2
Check for obstructions in the area of the media feed
path in the ADF.
Is the media feed path free from any obstructions?
3
Is the ADF left cover assembly properly and evenly
closed.
4 Check the ADF/pick roll assembly for damage and
wear.
Is the ADF feed/pick roll assembly free from damage
and wear?
5 Check the separation guide assembly.
Is the separation guide assembly free from damage and
wear?
6 Check the ADF controller card assembly.
Replace the ADF controller card assembly.
"ADF controller card assembly removal" on
Go to
page 4-138.
Perform a print test using the ADF.
Does the error continue?
Check Yes
Go to step 2. Problem solved.
Go to step 3. Remove
obstructions.
Go to step 4. Open then
properly close
the ADF left
cover assembly.
Go to step 5. Replace the ADF
feed/pick roll
assembly.
Go to
feed/pick roll
assembly
removal" on
page
Go to step 6. Replace the
separation guide
assembly.
Go to
separation roll
guide
assembly" on
page
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-73.
Diagnostic information
7510
No
"ADF
4-142.
"ADF
4-155.
2-241