Setup And Adjustments; Sensor (Atc) Setup - Lexmark X940e Service Manual

Hide thumbs Also See for X940e:

Table of Contents

Setup and adjustments

Warning: Before installing any new developer unit assembles in the machine, record the bar code

number located on the sensor (ATC) for all new developer units being installed.

Sensor (C ATC) XXX

Sensor (M) ATC XXX

Sensor (Y) ATC XXX

Sensor (K) ATC XXX

Using the bar code number recorded from the sensor (ATC) on each of the new developer unit

assemblies in step 1, locate the values for the following settings using the ATC value conversion chart

shown after step 5:

Sensitivity gradient

Sensor output reference

Warning: The following step must be performed or the new machine settings will not match the

settings listed on the birth certificate in the event it is required for NVM value replacement.

Retrieve the birth certificate from the compartment in the media tray 1, record the eight new sensitivity

gradient and sensor output reference settings from step 2 to the birth certificate.

Repair information