Adf Feed-Out Roll Assembly Removal - Lexmark X940e Service Manual

14. Remove the two screws securing the sensor mount (A) to the ADF.
15. Slide the sensor mount (A) from the underside of the ADF transport roll (B), and move it out of the way.
16. Remove the tension spring (C).
17. Loosen the screw securing the tension bracket (D), and loosen the registration secondary drive belt (E) tension.
18. Remove the plastic clip securing the registration roll drive pulley 28T (F).
19. Slide the registration secondary drive belt (E) from the registration roll drive pulley 28T (F).
20. Remove the ADF registration motor. See
21. Remove the registration roll drive pulley 28T (F).
22. Remove the bearing 8 mm (G) securing the ADF registration roll assembly (H) to the rear of the feed assembly.
23. Remove the plastic clip securing the bearing 8 mm (I) of the front side.
24. Remove the bearing 8 mm (I) securing the ADF registration roll assembly (H) to the front of the feed assembly.
25. Move the ADF registration roll assembly (H) frontward and upward.
26. Remove the ADF registration roll assembly (H).
Warning: Do not touch the rubber surface of the ADF registration roll assembly (H).
Replacement note: Before reinstalling the registration secondary drive belt (E), ensure that it is routed properly.
Replacement note: Loosen and then retighten the two screws that set the belt tension after the tension spring
(C) is attached.

ADF feed-out roll assembly removal

1. Remove the platen cushion assembly. See
1. Remove the ADF unit assembly. See
2. Open the ADF left cover assembly.
3. Remove the ADF front cover assembly. See
4. Remove the ADF rear cover. See
5. Remove the ADF left cover media guide. See
6. Remove the left cover pinch roll assembly. See
7. Remove the ADF left cover assembly. See
8. Remove the document tray assembly. See
"ADF registration motor removal" on page
A
H
I
Plastic
clip
"Platen cushion removal" on page
"ADF unit assembly removal" on page
"ADF front cover assembly removal" on page
"ADF rear cover removal" on page
"ADF left cover media guide removal" on page
"ADF left cover assembly removal" on page
"Document tray assembly removal" on page
B
C
D
F
Plastic
clip
G
Front
4-131.
"Left cover pinch roll assembly removal" on page
4-159.
E
4-130.
4-129.
4-131.
4-144.
4-132.
4-137.
4-153
Repair information
7510
4-134.