Sensor (Adf Media Exit) Static Jam Service Check - Lexmark MX81 Series Service Manual

Action
Step 5
Check the ADF transport motor for proper operation.
a
Enter the Diagnostics Menu.
b
Touch TESTS.
c
Touch Transport Motor/Deskew Clutch.
d
Touch either Motor Forward or Motor backward
e
Perform test.
Does the ADF pick motor operate properly?
Step 6
Check the ADF transport motor for proper connection.
Is the above component properly connected?
Step 7
Place an undamaged document in the ADF, and perform a ADF test.
Does the error remain?
Step 8
Perform a print test using the ADF.
Does the problem remain?

Sensor (ADF media exit) static jam service check

Action
Step 1
Check the media size setup and tray guides for the ADF. Does the media
size, in use, match the size set for the ADF
Step 2
Check the sensor (ADF media exit) for proper operation.
a
Enter the Diagnostics Menu.
b
Touch SCANNER TESTS.
c
Touch Sensor Tests.
d
Observe the line "sensor (ADF media exit)."
Does the display on the operator panel change every time the sensing
area of the above sensor is interrupted or blocked?
Yes
Go to
Replace the ADF rear
side drive parts pack.
Go to
drive parts pack
removal" on page
472.
Replace the ADF
controller PCBA.
Contact the next
highest level of
support.
Yes
Go to step 2.
Go to
Diagnostic information
129
No
step 7. Go to step 6.
Replace the
connection.
"ADF rear side
Problem solved.
Problem solved.
No
Replace the media, or
change the media size
setup.
step 4. Go to step 3.
7463