Media Damage (Using Adf) - Lexmark X925 Service Manual

Media damage (using ADF)

Step
1 Properly load document into the ADF unit assembly and
ensure all guides are set correctly.
Re-print the defective image.
Does the error continue?
2 Check for obstructions in the area of the media feed
path in the ADF.
Is the media feed path free from any obstructions?
3 Is the ADF left cover assembly properly and evenly
closed?
4 Check the ADF/pick roll assembly for damage and
wear.
Is the ADF feed/pick roll assembly free from
damage and wear?
5 Check the ADF separator roll.
Is the separator roll free from damage and wear?
6 Check the ADF controller card assembly.
Replace the ADF relay board assembly.
Go to
Perform a print test using the ADF.
Does the error continue?
Check
"ADF relay board" on page
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
Go to step 6.
Replace the RIP
board.
Go to
4-122.
board removal"
on page
7541-03x
Yes No
Problem solved.
Remove
obstructions.
Open then
properly close
the ADF left
cover assembly.
Replace the ADF
feed/pick roll
assembly.
Go to "ADF pick
roll removal" on
page 4-114.
Replace the
separator roll.
Go to "ADF
separator roll
removal" on
page 4-115.
Problem solved.
"RIP
4-73.
Diagnostic information
2-15