Adjusting The Margins For Scanning An Original On The Contact Glass - Kyocera Mita KM-1505 Service Manual

2BT

(10) Adjusting the margins for scanning an original on the contact glass

Perform the following adjustment if the margins are not correct.
U402
U403
(P. 1-6-10)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "403" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp. 1(lit): Scanner left margin
Exp. 3(lit): Scanner leading edge
margin
Exp. 5(lit): Scanner right margin
Exp. 1(flashing): Scanner trailing
edge margin
Press the size select key and the
machine enters the test copy mode.
Place an original and press
the start key to make a test copy.
Are the margins correct?
Yes
Proceed to another mode?
Press the stop/reset key to
exit maintenance mode.
1-6-26
Start
Ejection direction
No
Yes
Setting range (initial setting/change in value per step)
No
End
Scanner leading edge margin (3 ± 2.5 mm)
(reference)
Scanner
left margin
(3 ± 2.5 mm)
Figure 1-6-43
Press the start key.
The new setting
is stored.
Change the setting.
Increasing the value using the zoom
(+) key makes the margin wider.
Decreasing the value using the
zoom (–) key makes the margin
narrower.
Scanner left margin: 0 – +10 (2.0/0.1 mm)
Scanner leading edge margin: 0 – +10 (3.0/0.1 mm)
Scanner right margin: 0 – +10 (2.0/0.1 mm)
Scanner trailing edge margin: 0 – +10 (2.0/0.1 mm)
Scanner
right margin
(3 ± 2.5 mm)
Scanner trailing edge margin
(3 ± 2.5 mm)