Switch Settings On Boards And Leds Description; Dme-3000/7000 - Sony DME-7000 Maintenance Manual

1-8. Switch Settings on Boards and LEDs Description

1-8. Switch Settings on Boards and
LEDs Description

1-8-1. DME-3000/7000

n
The addresses on the boards are shown by ( ) marks.
CPU-114 board (DME-3000 only)
18
17
(*1)
S301
16
15
3
S1
2 ND301
1 A B C D E
(*1) : DME-3000 (serial number 10001 through 10210)
only
[Switch]
S1(G-1) : Reset switch
Resets the CPU on the CPU-114 board.
S2(H-1) : Interrupt switch
Executes the interrupt processing so as to receive the
communication data from an RS-232C port.
n
Do not press this switch in normal times.
(* * * * * 1)
S301-1(D-16 /J-1) : Memory clear switch
ON: Erases the key frame data when the power
is turned on.
OFF: Backs up the key frame data.
Factory setting: OFF
1-14 (E)
S2
S301
F G H J
K L M N
A side ( Component side )
S301-2(D-16 (* * * * * 1) /J-1) : Editor protocol selector
Selects the protocol of the D-sub Editor connector on the
rear panel.
ON: VTR protocol
OFF: DME protocol
(BVE-9000/9100 + BKE-9009)
Factory setting: OFF
When the software V1.40 or later is installed:
Editor protocol can be set by the setup menu (702 OPERA-
TION).
POWER ON mode
Mode
Factory set
When power Switch setting
is turned on takes effect.
When protocol Menu setting
is reset by takes effect.
setup menu
S301-3, 4(D-16 (* * * * * 1) /J-1):
The functions of these switches depend on installed
operating software's version.
S301-3 and S301-4 are set to OFF at the factory.
When the software V1.00 is installed: AUX protocol
selector
Selects the protocol of the D-sub AUX connector on the
rear panel.
S301-3 S301-4
OFF OFF
ON OFF
ON ON
When the software V1.11 or later is installed: Factory use
These switches are used for the adjustment in the factory.
AUX protocol can be set by the setup menu (711 SOURCE
SELECTOR).
n
Be sure to set S301-4 to OFF.
User define
Menu setting
takes effect.
Menu setting
takes effect.
Selected protocol
CART protocol
(DVS-V1201, BKDM-5080)
SWITCHER protocol
(DVS-8000/6000/2000 series)
Not used.