Dvi Digital Video; Dual Sd/Hd-Sdi - Christie Mirage S+/HD/WU User Manual

2.4.4 DVI Digital Video

Use the DVI-I connector at INPUT 2 to connect either analog or digital video devices to the projector. When
connecting devices that transmit an analog video signal such as VCRs, laptops, and PCs use the DVI cable
provided with the projector. Plug the DVI-I (single link) connector end to the projector and the 15-pin VGA
connector to the device.
Use a cable with DVI-I connectors at both ends to connect devices that transmit digital and analog video
signals such as high-quality DVD players, satellite receiver and digital cable TVs.
NOTES: 1) To ensure true digital output from devices that transmit digital signals, connect to the DVI-I
connector. 2) DVI loop through is not available unless you have the optional DVI Input Module
installed at INPUT 5 or INPUT 6.

2.4.5 Dual SD/HD-SDI

Christie's Dual SD/HD-SDI input module is standard with Roadster models and factory-installed in INPUT 5
or INPUT 6. The module's loop-through capability enables incoming serial digital data to be tiled across
multiple screens, creating vast "mega resolution" displays. Alternatively, the multiple outputs can be
overlapped for extra-bright displays, or simply distributed to additional projectors for multiple screens of the
same image.
The module accepts 1 or 2 independent standard- or high-definition serial digital inputs, decodes them for
processing in the main electronics of the projector, and outputs 10-bit YCbCr 4:2:2 video. Either input can be
set as the active primary or secondary part of a Picture-in-Picture (PIP) display, and either input can be looped
through to 1 (or both) of the module's BNC outputs.
NOTE: Selection of these inputs is described in
Connect a compatible SMPTE 292M or SMPTE 259M-C source(s) to 1 or both of the inputs located on the left
side of the module. The module will automatically detect the standard at each input and configure itself
accordingly for correct termination of the signal. The module also detects and supports dual link 292M and
SMPTE 372M video standards. For full details, consult the Dual SD/HD-SDI manual.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
Figure 2-30 Connecting Composite Video
Section 3.2 Using the
Section 2: Installation and Setup
Keypads.
2-21