G250/G350 Serial Modems; Accessing The Cli Via A Modem Connection To The S8300 - Avaya G250 Administration

6. Configure the serial connection on the remote computer to match the configuration of the
console port on the G250/G350. The console port settings are the same as the USB port
settings in

G250/G350 serial modems

The G250/G350 supports the following serial modems:
Multitech MultiModem ZBA, MT5634ZBA-V92.
●
Multitech BRI-NT1 ISDN Modem w/ POTS, MTA128NT, for use in US/Canada.
●
Multitech ISDN Modem w/ POTS, MTA128STBRI, for use in Europe and the rest of the
●
world. The ISDN modems require DB-25 termination as well as the RJ-45 cable.

Accessing the CLI via a modem connection to the S8300

If the Avaya G250/G350 Media Gateway includes an S8300 Media Server, you can access the
CLI from a remote location. This is done by establishing a PPP network connection from a
modem at the remote location, to a USB modem connected to the one of the USB ports on the
front panel of the S8300. The G250/G350 supports the Multitech MultiModem USB,
MT5634ZBA-USB-V92.
Note:
In order to access the CLI via the S8300, the PMI of the G250/G350 must be
Note:
configured. See
page 70.
1. Connect a USB modem to either of the two USB ports on the Avaya S8300 Media Server.
2. Use the Avaya Maintenance Web Interface (MWI) to configure the USB port on the S8300
for modem use. For instructions, see Installing and Upgrading the Avaya G250 Media
Gateway, 03-300434 or Installing and Upgrading the Avaya G350 Media Gateway,
03-300394.
3. From a remote computer, create a dialup network connection to the S8300. Use the TCP/
IP and PPP protocols to create the connection.
4. Open any standard telnet program on the remote computer.
5. Enter the command telnet, followed by the IP address of the S8300 USB port to which
the modem is connected.
6. Enter the command telnet, followed by the PMI of the G250/G350.
Table 1 except for the baud parameter, which uses the highest possible setting.
Configuring the Primary Management Interface (PMI)
Accessing the CLI via modem
on
Issue 3 February 2007 39